Small Wall Heater - Q'Mark CWH 1000 Series

CWH1000 Series - Commercial Fan-Forced Wall Heaters by Q'Mark Marley 

•    Fast heat response, compact design and versatility make the CWH1000 Series heaters ideal for dens, basements, converted attics, breezeways, garages, bathrooms, small offices, workshops and similar areas. Also, adaptable to multiple installations in somewhat larger or odd shaped room

•    Fan delay: On a call for heat, element is energized but fan is delayed until element is warm, eliminating the circulation of cold air during start up. When the thermostat is satisfied, the element is de-energized, but the fan continues until all heated air is discharged providing longer component life and higher comfort level

•    Motor is totally enclosed, impedance protected with permanently lubricated bearings

•    Airflow system maximizes air volume at minimum noise level; 65 CFM

•    Rugged louvered commercial grade steel grille creates downflow air pattern

•    This heater is designed for installation in 2x4 or larger wall sections using the wall box provided. The heater may also be surface mounted to the wall by using the Surface Mounting Frame, Model No. CWHSM (order separately)

•    Includes built-in disconnect switch

Northern White baked enamel finish

Q'Mark CWH1101DS  1000/500 watts  8.4/4.2 amps  120 volts

Q'Mark CWH1151DS  1500/750 watts  12.5/6.25 amps  120 volts

Q'Mark  

CWH1201DS  1800 watts  15 amps  120 volts

Q'Mark CWH1202DS   2000/1000 watts  8.3/4.2 amps  240 volts

Q'Mark CWH1157DS   1500/750 watts  5.5/2.75 amps  277 volts

Q'Mark CWH1207DS   2000/1000  watts  7.2/3.61 amps  277 volts

Q'Mark CWH1208DS   2000/1000  watts  9.6/4.8 amps  208 volts

Q'Mark CWHSM  surface mounting frame (Accessory)

Q'Mark CWHS1  1 inch  Semi-Recess Mounting

Q'Mark CWHS2  2 inch  Semi-Recess Mounting

MOUNTING LIMITATIONS

1. Do not install heater closer than 4” from

floor.

2.Do not install heater behind towel rack,

behind door, in floor, in ceiling, in closet,

or where air flow may be obstructed.

HEATING ELEMENT: The heating element shall be of the

non-glowing design consisting of an 80/20 nickel-chromium

resistance wire enclosed in a steel sheath to which plate fins

are copper brazed. It shall be warranted for 5 years.The

element shall cover the entire air discharge area to ensure

uniform heating of all discharge air.

MOTOR AND CONTROLS: The fan motor shall be

impedance protected, permanently lubricated and with totally

enclosed motor. Fan control shall be of the bi-metallic, snapaction

type and shall activate fan after heating element

reaches operating temperature, and continue to operate the

fan after the thermostat is satisfied and until all heated air has

been discharged.The thermostat shall be single pole type on

all models. Thermal cutout shall be bi-metallic, snap-action

type designed to shut off heat in the event of overheating. The

fan shall be five-bladed aluminum. The fan motor shall be

totally enclosed.

216-360-9800

www.anderson-bolds.com